[    0.093499] platform ff770000.syscon:phy@f780: Fixing up cyclic dependency with fe330000.mmc
[    1.053040] dwmmc_rockchip fe320000.mmc: IDMAC supports 32-bit address mode.
[    1.053065] dwmmc_rockchip fe320000.mmc: Using internal DMA controller.
[    1.053079] dwmmc_rockchip fe320000.mmc: Version ID is 270a
[    1.053097] dwmmc_rockchip fe310000.mmc: IDMAC supports 32-bit address mode.
[    1.053122] dwmmc_rockchip fe310000.mmc: Using internal DMA controller.
[    1.053123] dwmmc_rockchip fe320000.mmc: DW MMC controller at irq 32,32 bit host data width,256 deep fifo
[    1.053131] dwmmc_rockchip fe310000.mmc: Version ID is 270a
[    1.053178] dwmmc_rockchip fe310000.mmc: DW MMC controller at irq 31,32 bit host data width,256 deep fifo
[    1.053448] dwmmc_rockchip fe310000.mmc: allocated mmc-pwrseq
[    1.053457] mmc_host mmc0: card is non-removable.
[    1.053486] dwmmc_rockchip fe320000.mmc: Got CD GPIO
[    1.055402] mmc2: CQHCI version 5.10
[    1.066778] mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[    1.082034] mmc2: SDHCI controller on fe330000.mmc [fe330000.mmc] using ADMA
[    1.127658] mmc2: mmc_select_hs200 failed, error -110
[    1.127689] mmc2: error -110 whilst initialising MMC card
[    1.179366] mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[    1.208948] mmc2: Command Queue Engine enabled
[    1.208979] mmc2: new HS200 MMC card at address 0001
[    1.210149] mmcblk2: mmc2:0001 DA4064 58.2 GiB 
[    1.214340]  mmcblk2: p1 p2
[    1.215136] mmcblk2boot0: mmc2:0001 DA4064 4.00 MiB 
[    1.216312] mmcblk2boot1: mmc2:0001 DA4064 4.00 MiB 
[    1.217364] mmcblk2rpmb: mmc2:0001 DA4064 16.0 MiB, chardev (235:0)
[    1.226728] mmc_host mmc0: Bus speed (slot 0) = 148500000Hz (slot req 150000000Hz, actual 148500000HZ div = 0)
[    2.110294] dwmmc_rockchip fe310000.mmc: Successfully tuned phase to 65
[    2.118890] mmc0: new ultra high speed SDR104 SDIO card at address 0001
[    3.326151] EXT4-fs (mmcblk2p2): mounted filesystem with ordered data mode. Quota mode: none.
[    4.222249] EXT4-fs (mmcblk2p2): re-mounted. Quota mode: none.
[    6.268918] brcmfmac mmc0:0001:1: Direct firmware load for brcm/brcmfmac43456-sdio.pine64,pinebook-pro.bin failed with error -2
[    6.406926] FAT-fs (mmcblk2p1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
[  154.841959] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 100000000Hz, actual 100000000HZ div = 0)
[  155.200035] dwmmc_rockchip fe320000.mmc: Successfully tuned phase to 204
[  155.200840] mmc1: new ultra high speed SDR50 SDXC card at address 59b4
[  155.202512] mmcblk1: mmc1:59b4 GF8S5 478 GiB 
[  155.205324]  mmcblk1: p1
[  156.319874] mmc1: card 59b4 removed
[  162.522347] mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[  162.700870] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 100000000Hz, actual 100000000HZ div = 0)
[  162.880357] dwmmc_rockchip fe320000.mmc: Successfully tuned phase to 204
[  162.881181] mmc1: new ultra high speed SDR50 SDXC card at address 59b4
[  162.882886] mmcblk1: mmc1:59b4 GF8S5 478 GiB 
[  162.885585]  mmcblk1: p1