[    0.093507] platform ff770000.syscon:phy@f780: Fixing up cyclic dependency with fe330000.mmc
[    1.054329] dwmmc_rockchip fe320000.mmc: IDMAC supports 32-bit address mode.
[    1.054356] dwmmc_rockchip fe320000.mmc: Using internal DMA controller.
[    1.054370] dwmmc_rockchip fe320000.mmc: Version ID is 270a
[    1.054415] dwmmc_rockchip fe320000.mmc: DW MMC controller at irq 32,32 bit host data width,256 deep fifo
[    1.054501] dwmmc_rockchip fe310000.mmc: IDMAC supports 32-bit address mode.
[    1.054526] dwmmc_rockchip fe310000.mmc: Using internal DMA controller.
[    1.054535] dwmmc_rockchip fe310000.mmc: Version ID is 270a
[    1.054588] dwmmc_rockchip fe310000.mmc: DW MMC controller at irq 31,32 bit host data width,256 deep fifo
[    1.055133] dwmmc_rockchip fe320000.mmc: Got CD GPIO
[    1.055270] dwmmc_rockchip fe310000.mmc: allocated mmc-pwrseq
[    1.055279] mmc_host mmc0: card is non-removable.
[    1.056799] mmc2: CQHCI version 5.10
[    1.067909] mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[    1.081586] mmc2: SDHCI controller on fe330000.mmc [fe330000.mmc] using ADMA
[    1.129639] mmc2: Command Queue Engine enabled
[    1.129662] mmc2: new HS200 MMC card at address 0001
[    1.130520] mmcblk2: mmc2:0001 DA4064 58.2 GiB 
[    1.133063] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 100000000Hz, actual 100000000HZ div = 0)
[    1.134155] dwmmc_rockchip fe320000.mmc: All phases bad!
[    1.134164] mmc1: tuning execution failed: -5
[    1.134174] mmc1: error -5 whilst initialising SD card
[    1.134474]  mmcblk2: p1 p2
[    1.135100] mmcblk2boot0: mmc2:0001 DA4064 4.00 MiB 
[    1.136142] mmcblk2boot1: mmc2:0001 DA4064 4.00 MiB 
[    1.137111] mmcblk2rpmb: mmc2:0001 DA4064 16.0 MiB, chardev (235:0)
[    1.148318] mmc_host mmc1: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[    1.179236] mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[    1.215180] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 100000000Hz, actual 100000000HZ div = 0)
[    1.216602] dwmmc_rockchip fe320000.mmc: All phases bad!
[    1.216611] mmc1: tuning execution failed: -5
[    1.231787] mmc_host mmc1: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[    1.276038] mmc_host mmc1: Bus speed (slot 0) = 50000000Hz (slot req 50000000Hz, actual 50000000HZ div = 0)
[    1.277046] mmc1: new high speed SDXC card at address 59b4
[    1.278060] mmcblk1: mmc1:59b4 GF8S5 478 GiB 
[    1.281504]  mmcblk1: p1
[    1.298501] mmc_host mmc0: Bus speed (slot 0) = 148500000Hz (slot req 150000000Hz, actual 148500000HZ div = 0)
[    2.151808] dwmmc_rockchip fe310000.mmc: Successfully tuned phase to 58
[    2.159707] mmc0: new ultra high speed SDR104 SDIO card at address 0001
[    3.345677] mmc_host mmc1: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[    3.397831] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 100000000Hz, actual 100000000HZ div = 0)
[    3.579379] dwmmc_rockchip fe320000.mmc: Successfully tuned phase to 205
[    4.000456] EXT4-fs (mmcblk2p2): mounted filesystem with ordered data mode. Quota mode: none.
[    4.883069] EXT4-fs (mmcblk2p2): re-mounted. Quota mode: none.
[    5.653554] brcmfmac mmc0:0001:1: Direct firmware load for brcm/brcmfmac43456-sdio.pine64,pinebook-pro.bin failed with error -2
[    5.993585] FAT-fs (mmcblk2p1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
[  205.056442] EXT4-fs (mmcblk1p1): mounted filesystem with ordered data mode. Quota mode: none.